Amplifier Research 80S1G4
Microwave Amplifier, 0.7 - 4.2 GHz, 80W

Download Product Datasheet

Product Overview

RENT AMPLIFIER RESEARCH 80S1G4 (Call for Availability)

The Amplifier Research 80S1G4 is a solid state, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain, and linearity are needed. It is housed in a stylish cabinet and designed for benchtop use, but can also be removed for equipment rack mounting as well. 

Features and Specifications of the Amplifier Research 80S1G4 include:

• Features:
• Provides a minimum of 80 watts of RF power when used with a sweep generator
• Front panel gain control allows the convenience of setting desired output level
• RF input leveling circuit:
• Controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm
• Protects the amplifier from RF input overdrive
• RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an over-temperature condition occurs due to cooling blockage or fan failure
• Digital display on the front panel indicates the operate status and fault conditions when an over-temperature or power supply fault has occurred
• All control functions and status indications are available remotely in GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet
• Bus interface connector on back panel
• Local/Remote switch on front panel assures positive control of local or remote operation
• Low level of spurious signals and linearity make it ideal for these various uses:
• As a driver amplifier in testing wireless and communication components and subsystems
• As a test instrument covering multiple frequency bands
• For communication technologies including: CDMA, W-CDMA, TDMA, GSM, etc.
• For EMC test applications where undistorted modulation envelopes are desired
• Specifications:
• Rated power output:  80 watts minimum
• Input for rated output:  1.0 milliwatt maximum
• Power Output@ 3dB compression:
• Nominal:  95 watts
• Minimum:  68B compression:
• Nominal:  85 watts
• Minimum:  70 watts
• Flatness: 
• Typical:  ±1.5 dB
• Maximum:  ±2.0 dB
• Frequency response:  0.7 – 4.2 GHz instantaneously
• Gain (at maximum setting):  49 dB minimum
• Gain adjustment (continuous range):  10 dB minimum (4096 steps remote)
• Input impedance:  50 ohms, VSWR 2.0:1 maximum
• Output impedance:  50 ohms, nominal
• Mismatch tolerance: 
• 100% of rated power without foldback
• Will operate without damage or oscillation with any magnitude and phase of source and load impedance
• Modulation capability:  Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
• Third order intercept point:  58 dBm typical
• Noise Figure:  10 dB typical
• Harmonic distortion:  Minus 20 dBc maximum at 80 watts
• Spurious:  Minus 73 dBc typical
• Phase Linearity:  ±1.0 deg/100 MHz typical
• Noise figure:  10 dB typical
• Primary power (selected automatically): 
• 90-132, 180-264 VAC
• 50/60 Hz, single phase
• 448 watts maximum
• Connectors:
• RF:  Type N female
• Remote interfaces:
• IEEE-488:  24 pin
• RS-232:  9 pin Subminiature D
• RS-232 (fiber optic):  Type ST
• USB 2.0:  Type B
• Ethernet:  RJ-45
• Safety interlock:  15 Pin Subminiature D
• Cooling:  Forced air (self contained fans)