Picotest J2120A
Line Injector

Download Product Datasheet

Product Overview

RENT PICOTEST J2120A Line Injector (Call for Availability)

    While the injection transformer is a very wideband adapter, it is not useful for measuring ripple rejection (PSRR) of a power supply or even an opamp.  This is because the attributes that make the injection transformer perform so well also result in a transformer that is intolerant of DC current.  Even very small DC currents (5mA or less) can greatly reduce the signal capacity or even totally saturate the transformer.  For this reason, the Picotest line injector (J2120A) is another essential test adapter. 

    The line injector allows the input DC supply voltage to be modulated by the network analyzer source signal, as in the case of a PSRR measurement.  The line injector must be capable of a frequency range well below the AC line frequency and at least above the control loop bandwidth of the circuit being tested. 

    The line injector is only capable of sourcing current, so that the output amplitude can be significantly impacted by the operating current and the total storage capacitance at the load.  The Bode-100 network analyzer has a very high selectivity so distortion at the output of the line injector generally does not influence the measurement.  Again, this is a small signal injector, so the oscillator signals should be kept as small as possible above the noise floor.  As a guide, try to keep the input signal amplitude below 50mVpp (-20dBm).  In some cases we want to attenuate the source signal even further, and so we have included the attenuators in the injector kits.  Some analyzers, such as the Omicron-Lab-Lab Bode-100 allow shaping the injection amplitude as a function of frequency, which helps optimize the signal level.

Key Features of the PICOTEST J2120A Line Injector Include:

• 10Hz-10MHz usable bandwidth
• Low loss design
• 5 Amps maximum current
• 50VDC max input
• Easily measure input filters and PSRR

See Datasheet for full specifications