Tektronix BSA286CL
Low Noise BERTScope 28.6 Gb/s Pattern Generator and Error Analyzer

Telecommunication and Wireless >> Bit Error Ratio Testers (BERT) >> Low Noise BERTScope 28.6 Gb/s Pattern Generator and Error Analyzer





Download Product Datasheet

Product Overview

Tektronix BSA286CL

Rent Tektronix BSA286CL Low Noise BERTScope 28.6 Gb/s Pattern Generator and Error Analyzer

The Tektronix BSA286CL BERTScope Bit Error Rate Tester Series provides a new approach to signal integrity measurements of serial data systems. Perform bit error rate detection more quickly, accurately, and thoroughly by bridging eye diagram analysis with BER pattern generation. The Tektronix BSA286CL BERTScope Bit Error Rate Tester Series enable you to easily isolate problematic bit and pattern sequences, then analyze further with advanced error analysis that deliver unprecedented statistical measurement depth.

The Tektronix BSA286CL's low intrinsic RJ supports serving of 802.3ba's simultaneous VECP (Vertical Eye Closure Penalty) and J2/J9 calibration with valuable margin required to fully characterize 100G Ethernet silicon.

The Tektronix BSA286CL BERTScope use an internal Double Data Rate (DDR) architecture to operate at data rates ≥11.2 Gb/s. When operating at 11.2 Gb/s or higher data rate, the clock output will be 1/2 the data rate. The external clock can be specified to be either full or half data rate. When full rate is selected, the pattern generator will operate in DDR mode when the input clock frequency is 11.2 GHz or higher.

Features and Specifications of the Tektronix BSA286CL includes:

• Sinusoidal Jitter - Internal SJ frequency 1 kHz to 100 MHz
• Maximum internal SJ amplitude 1100 ps^{2 -} 270ps³ 
• Data Outputs- 1 to 28.6 Gb/s
• Clock Outputs- 1-28.6 GHz 8
• Data Clock Waveform Performance: ≤8 psp-p TJ (@28.05 Gb/s) typical ≤300 fs RMS Random Jitter (@28.05 Gb/s) typica

 

Click to see all the models in this series