Tektronix Encore




Amplifier Research 500T7Z5G18
Microwave Amplifier, 7.5 - 18 GHz, 500W

Amplifiers - RF and Microwave >> Above 1 GHz and 101 Watt to 999 Watt >> Microwave Amplifier, 7.5 - 18 GHz, 500W
Rent Used Test Equipment
Manufacturer: Amplifier Research
Model: 500T7Z5G18

Amplifier Research 500T7Z5G18 Microwave Amplifier, 7.5 - 18 GHz, 500W

Electronic Test and Measurement Equipment

Amplifier Research 500T7Z5G18 Microwave Amplifier, 7.5 - 18 GHz, 500W Product Datasheet Download Product Datasheet

Rent Test Equipment

Product Overview

RENT AR 500T7z5G18 (call for availability)

The Amplifier Research (AR) 500T7z5G18 is a self contained, forced air cooled, broadband traveling wave tube (TWT) microwave amplifier designed for applications where instantaneous bandwidth, reduced harmonics and high gain are required. A reliable TWT subsystem provides a conservative 500 watts minimum at the amplifier output connector. Stated power specifications are at fundamental frequency.

The AR 500T7z5G18 Amplifier's front panel digital display shows forward and reflected output plus extensive system status information accessed through a series of menus via soft keys. Status indicators include power on, warm-up, standby, operate, faults, excess reflected power warning and remote. Standard features include a built-in IEEE-488 (GPIB) interface, 0 dBm input, VSWR protection, gain control, RF output sample port, plus monitoring of TWT helix current, cathode voltage, collector voltage, heater current, heater voltage, baseplate temperature and cabinet temperature.

The modular design of the AR 500T7z5G18 Amplifier's power supply and RF components allow for easy access and repair. Use of a switching mode power supply results in significant weight reduction.

The rated power is developed by efficiently power combining the outputs from two 300 watts (nominal) microwave tubes that are factory matched in gain and phase to offer moderate harmonic levels without added filters.

Housed in a stylish contemporary cabinet, the AR 500T7z5G18 Amplifier is designed for bench top use, but can be removed from cabinet for rack mounting. The AR 500T7z5G18 Amplifier provides readily available RF power for a variety of applications in Test and Measurement, (including EMC RF susceptibility testing), Industrial and University Research and Development, and Service applications.

Features and specifications of the AR 500T7z5G18 Amplifier include:

  • Power (fundamental), CW, @ Output Connector:
    • Nominal: 550 watts
    • Minimum: 500 watts
    • Linear @ 1 dB Compression: 125 watts minimum
  • Flatness: ±11 dB maximum, equalized for ±3 dB maximum at rated power
  • Frequency Response: 7.5 - 18 GHz instantaneously
  • Input for Rated Output: 1.0 milliwatt maximum
  • Gain (at maximum setting): 57 dB minimum
  • Gain Adjustment (continuous range): 35 dB minimum
  • Input Impedance: 50 ohms, VSWR 2.0:1 maximum
  • Output Impedance: 50 ohms, VSWR 2.5:1 typical
  • Mismatch Tolerance: Output power foldback protection at reflected power exceeding 100 watts. Will operate without damage or oscillation with any magnitude and phase of source and load impedance. May oscillate with unshielded open due to coupling to input. Should not be tested with connector off.
  • Modulation Capability: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal. AM peak envelope power limited to specified power.
  • Noise Power Density: Minus 70 dBm/Hz (maximum), Minus 72 dBm/Hz (typical)
  • Harmonic Distortion: Minus 20 dBc maximum, Minus 22 dBc typical
  • Primary Power: 208 VAC ± 10% three phase 50/60 Hz 4 KVA maximum
  • Connectors:
    • RF input: Type N precision female on rear panel
    • RF output: Type WRD-750D24 waveguide flange on rear panel
    • RF output sample port: Type N precision female on rear panel
    • GPIB: IEEE – 488 (f) on rear panel
    • Interlock: DB-15 (f) on rear panel
  • Cooling: Forced air (self contained fans), air entry and exit in rear.

Request A Quote

Rent      Buy      Repair
SUBMIT REQUEST
760-806-6600


Testimonial







Home   |   Rental Equipment   |   Equipment Sales   |   Repair & Calibration   |   Sell Your Equipment   |   About Us   |   Contact   |   Get A Quote   |   Blog    


Facebook Google Plus Paypal
Get the latest deals first. Subscribe to our newsletter.    SUBSCRIBE


© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML     
© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML

Axiom Test Equipment
2610 Commerce Way Vista, CA 92081
Phone: (760) 806-6600