Rent or Buy Amplifier Research 250S1G2Z5 Microwave Amplifier, 1 - 2.5 GHz, 100W


Tektronix Encore




Amplifier Research 250S1G2Z5
Microwave Amplifier, 1 - 2.5 GHz, 100W

Amplifiers - RF and Microwave >> Above 1 GHz and 100W or Less >> Microwave Amplifier, 1 - 2.5 GHz, 100W
Rent Used Test Equipment
Manufacturer: Amplifier Research
Model: 250S1G2Z5

Amplifier Research 250S1G2Z5 Microwave Amplifier, 1 - 2.5 GHz, 100W

Electronic Test and Measurement Equipment

Amplifier Research 250S1G2Z5 Microwave Amplifier, 1 - 2.5 GHz, 100W Product Datasheet Download Product Datasheet

Rent Test Equipment

Product Overview

RENT AMPLIFIER RESEARCH 250S1G2Z5 (Call for Availability)

The Amplifier Research 250S1G2z5 is a self-contained, air-cooled, broadband amplifier designed for applications that require instantaneous bandwidth, high gain, and linearity. It is housed in a stylish cabinet and designed for benchtop use, but can be removed for equipment rack mounting.

Features and Specifications of the Amplifier Research 250S1G2z5Amplifier include:

  • Features:
    • Provides a minimum of 250 watts of RF power when used with a sweep generator
    • Front panel gain control provides convenience of setting desired output level
    • RF input leveling circuit:
      • Protects the amplifier from RF input overdrive
      • Controls RF input level to the RF amplifier first stage when RF input level is increased above 0 dBm
    • RF amplifier stages are protected from over-temperature, due to cooling blockage or fan failure, by removing the DC voltage to them 
    • Digital Display on front panel indicates operate status and fault conditions when over-temperature or power supply fault occurs
    • Control functions and status indications are available remotely in GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB and Ethernet
    • Bus interface connector on back panel
    • Local/Remote switch on front panel assures positive control of local or remote operation
    • Low level of spurious signals and linearity make it ideal for these uses:
      • As a driver amplifier in testing wireless and communication components and subsystems
      • As a test instrument covering mutiple frequency bands
      • For communication technologies including CDMA, W-CDMA, TDMA, GSM, etc.
      • EMC Test applications where undistorted modulation envelopes are preferred
  • Specifications:
    • Rated output power:  250 watts minimum
    • Input for rated output:  1.0 milliwatt maximum
    • Power output @ 3dB compression:
      • Nominal:  275 watts
      • Minimum:  225 watts
    • Power output @ 1dB compression:
      • Nominal:  200 watts
      • Minimum:  175 watts
    • Average output power @ 3.2 GHz and above:  less than 60 watts
    • Flatness:
      • typical:  ±1.5 dB
      • maximum:  ±2.0 dB
    • Frequency response:  1.0 – 2.5 GHz instantaneously
    • Gain (at maximum setting):  54 dB minimum
    • Gain adjustment (continuous range):  20 dB minimum (4096 steps remote)
    • Input impedance:  50 ohms, VSWR 2.0:1 maximum
    • Output impedance:  50 ohms nominal
    • Mismatch tolerance:  
      • 100% of rated power without foldback
      • Will operate without damage or oscillation with any magnitude and phase of source and load impedance
    • Modulation capability:  Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
    • Third order intercept point:  64 dBm typical
    • Noise figure:  10 dB typical
    • Harmonic distortion:  Minus 20 dBc maximum at 175 watts
    • Spurious:  Minus 73 dBc typical
    • Phase linearity:  ±1.0 deg / 100 MHz typical
    • Primary power (selected automatically): 
      • 90-264 VAC
      • 50/60 Hz, single phase
      • 1250 watts maximum
    • Connectors:
      • RF:  Type N female
      • Remote Interfaces:
        • IEEE-488:  24 pin
        • RS-232:  9 pin Subminiature D
        • RS-232 (fiber-optic):  Type ST
        • USB 2.0:  Type B
        • Ethernet:  RJ-45
    • Safety Interlock:  15 pin Subminiature D
    • Cooling:  Forced air (self contained fans) 

Request A Quote

Rent      Buy      Repair
SUBMIT REQUEST
760-806-6600


Testimonial







Home   |   Rental Equipment   |   Equipment Sales   |   Repair & Calibration   |   Sell Your Equipment   |   About Us   |   Contact   |   Get A Quote   |   Blog    


Facebook Google Plus Paypal
Get the latest deals first. Subscribe to our newsletter.    SUBSCRIBE


© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML     
© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML

Axiom Test Equipment
2610 Commerce Way Vista, CA 92081
Phone: (760) 806-6600