Rent Amplifier Research 100S1G2z5A Microwave Amplifier (Call for Availability):
The Amplifier Research Model 100S1G2z5A is a self-contained, air-cooled, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a single equipment rack, the Amplifier Research100S1G2z5A provides readily available RF power for typical applications, such as RF susceptibility testing, antenna and component testing, watt meter calibration, and as a driver for frequency multipliers and higher power amplifiers. A safety interlock can be implemented via a rear panel connector.
The Amplifier Research 100S1G2z5A, when used with a sweep generator, will provide a minimum of 100 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The Amplifier Research 100S1G2z5A is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an overtemperature condition occurs due to cooling blockage or fan failure.
The Model 100S1G2z5A is equipped with a Digital Control Panel (DCP) which provides both local and remote control of the amplifier. The DCP uses a color LCD touch screen and a single rotary knob to offer status reporting and control capability. The display provides Forward Power and Reflected Power values plus amplifier status. Special features include a gain control and RF output level protection.
All amplifier control functions and status indications are available remotely in GPIB/IEEE- 488 format, RS232 hardwire and fiber optic, USB and Ethernet. The BUS interface connector is located on the back panel and positive control of local or remote operation is assured by a keylock on the front panel of the amplifier.
The low level of spurious signals and linearity of the Amplifier Research 100S1G2z5A make it ideal for use as a driver amplifier in testing wireless and communication components and subsystems. It can be used as a test instrument covering multiple frequency bands and is suitable for a variety of communication technologies such as CDMA, WCDMA, TDMA, GSM etc. It is also suitable for EMC Test applications where undistorted modulation envelopes are desired. The export classification for this equipment is EAR99. These commodities, technology or software are controlled for export in accordance with the U.S. Export Administration Regulations. Diversion contrary to U.S. law is prohibited.
Functions and Specifications of the Amplifier Research 100S1G2z5A Microwave Amplifier Includes:
RATED OUTPUT POWER: 100 watts minimum
INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
POWER OUTPUT @ 3dB COMPRESSION:
Nominal, 120 watts;
Minimum, 90 watts
POWER OUTPUT @ 1dB COMPRESSION:
Nominal, 100 watts;
Minimum, 70 watts
FLATNESS: ±1.5 dB typical, ±2.0 dB maximum
FREQUENCY RESPONSE: 1.0-2.5GHz instantaneously
GAIN (at maximum setting): 50 dB minimum
GAIN ADJUSTMENT: Continuous Range, 4096 steps remote, 20 dB minimum
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE: 50 ohms nominal
MISMATCH TOLERANCE: 100% of rated power without foldback. Will operate
without damage or oscilla- tion with any magnitude and phase
of source and load impedance.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or
pulse modulation appearing on the input signal.
THIRD ORDER INTERCEPT POINT: 60 dBm typical
NOISE FIGURE: 10 dB typical
HARMONIC DISTORTION: Minus 20 dBc maximum at 70 watts
SPURIOUS: Minus 73 dBc typical
PHASE LINEARITY: ±1 deg/100 MHz, Typical
PRIMARY POWER: 90-264 VAC, 50/60 Hz, single phase, 650 watts maximum
COOLING: Forced air (self-contained fans)
EXPORT CLASSIFICATION: EAR99
Request A Quote
Customers who viewed this also viewed
Amplifier Research 30W1000M7 RF Amplifier, 25 MHz to 1 GHz, 30W
Amplifier Research 25S1G4A Microwave Amplifier, 0.8 - 4.2 GHz, 25W
Milmega AS0825-65 Broadband Amplifier, 0.8 GHz - 2.5 GHz, 65W
IFI Instruments ST181-20 Microwave Amplifier, 1 - 18 GHz, 20W