Tektronix Encore




Amplifier Research 1000T8G18B
Microwave Amplifier, 7.5 - 18 GHz, 1000W

Amplifiers - RF and Microwave >> Above 1 GHz and 1000 Watt or More >> Microwave Amplifier, 7.5 - 18 GHz, 1000W
Rent Used Test Equipment
Manufacturer: Amplifier Research
Model: 1000T8G18B

Amplifier Research 1000T8G18B Microwave Amplifier, 7.5 - 18 GHz, 1000W

Electronic Test and Measurement Equipment

Amplifier Research 1000T8G18B Microwave Amplifier, 7.5 - 18 GHz, 1000W Product Datasheet Download Product Datasheet

Rent Test Equipment

Product Overview

Rent Amplfier Research 1000T8G18B TWT Amplifier (Call for Availability):

 

The Amplifier Research 1000T8G18B is a self contained, forced air-cooled, broadband traveling wave tube (TWT) microwave amplifier designed for applications where instantaneous bandwidth, high gain and high power output are required. Reliable TWT subsystems provide a conservative 1000 watts minimum at the amplifier output connector over most of the frequency range. Stated power specifications are at fundamental frequency. The amplifier's front panel digital display shows forward and reflected output plus extensive system status information accessed through a series of menus via soft keys. Status indicators include power on, warm-up, standby, operate, faults, excess reflected power warning and remote. Standard features include a built-in IEEE-488 (GPIB) interface, 0 dBm input, VSWR protection, gain control, RF output sample ports, auto sleep, plus monitoring of TWT helix current, cathode voltage, collector voltage, heater current, heater voltage, baseplate temperature and cabinet temperature. Modular design of the power supply and RF components allow for easy access and repair. Use of a switching mode power supply results in significant weight reduction. The rated power is developed by efficiently power combining the outputs from four 300 watts (nominal) microwave tubes that are factory matched in gain and phase to offer moderate harmonic levels without added filters. Amplifier includes wheels, leveling feet and hooks for lifting. The Amplifier Research 1000T8G18B provides readily available RF power for a variety of applications in Test and Measurement, (including EMC RF susceptibility testing), Industrial and University Research and Development, and Service applications. Unit is CE marked to comply with EMC European Directive 89/336/EEC for operation inside a shielded room. Refer to the Amplifier Research Configuration Chart for alternative configurations and special features. 

 

Functions and Specifications of the Amplifier Research 1000T8G18B Includes:

 

POWER (fundamental) , CW, @ OUTPUT CONNECTOR

Nominal: 1100 watts

Minimum: 1000 watts 7.5-17 GHz, 925 watts 17-18 GHz

Linear @ 1dB Compression: 250 watts minimum

 

FLATNESS: ±11 dB maximum, equalized for ±3 dB maximum

at rated power

 

FREQUENCY RESPONSE: 7.5–18 GHz instantaneously

 

INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum

 

GAIN (at maximum setting): 60 dB minimum

 

GAIN ADJUSTMENT (continuous range): 35 dB minimum

 

INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum

 

 

OUTPUT IMPEDANCE: 50 ohms, VSWR 2.5:1 typical

 

MISMATCH TOLERANCE: Output power foldback protection at

reflected power exceeding 200 watts. Will operate without

damage or oscillation with any magnitude and phase of

source and load impedance. May oscillate with unshielded

open due to coupling to input. Should not be tested with

connector off.

 

MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or

pulse modulation appearing on the input signal. AM peak

envelope power limited to specified power.

 

NOISE POWER DENSITY: Minus 70 dBm/Hz (maximum)

Minus 72 dBm/Hz (typical)

 

HARMONIC DISTORTION: Minus 20 dBc maximum,

Minus 27 dBc typical

 

PRIMARY POWER: See Model Configurations

 

CONNECTORS:

RF input: Type N female

RF output: Type WRD 750D24 waveguide flange on rear panel

RF output sample ports (forward and reflected): Type N female

GPIB: IEEE-488 female

Interlock: DB-15 female on rear panel

 

COOLING: Forced air (self contained fans), air entry and exit in rear.

 

WEIGHT (approximate) : 295 kg (650 lb)

SIZE (WxHxD): 56 x 160 x 82.3 cm (22.1 x 63 x 32.4 in)

Request A Quote

Rent      Buy      Repair
SUBMIT REQUEST
760-806-6600


Testimonial







Home   |   Rental Equipment   |   Equipment Sales   |   Repair & Calibration   |   Sell Your Equipment   |   About Us   |   Contact   |   Get A Quote   |   Blog    


Facebook Google Plus Paypal
Get the latest deals first. Subscribe to our newsletter.    SUBSCRIBE


© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML     
© 2019 Axiom Test, All Rights Reserved
FAQ      Privacy      Terms      Site Map      Site Map XML

Axiom Test Equipment
2610 Commerce Way Vista, CA 92081
Phone: (760) 806-6600