Amplifier Research 75A400
RF Amplifier, 10kHz - 400MHz, 75W

Amplifiers - RF and Microwave >> 1 GHz or Less and 100 Watt or Less >> RF Amplifier, 10kHz - 400MHz, 75W





Download Product Datasheet

Product Overview

Rent Amplifier Research 75A400 Amplifier (Call for availability):

 

The Amplifier Research 75A400 amplifier is a portable, self-contained, air-cooled, broadband, solid state amplifier unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. When used with an RF sweep generator, the 75A400 will provide a minimum of 75 watts of swept RF output power.

The Amplifier Research 75A400 includes a front panel RF Gain Control, which permits the operator to conveniently set the amplifier's desired output level. Housed in a stylish contemporary enclosure, the unit provides instantaneous power for typical applications such as RF susceptibility testing, antenna and component testing, Watt-meter calibration and as a driver for higher power amplifiers. The 75A400 is powered by a high efficiency switching supply, with autoranging AC input circuitry which will automatically accept voltages from 90 to 135 VAC, or from 180 to 270 VAC, in the 47 to 63 Hz frequency range. The RF Amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to a cooling blockage or fan failure. The digital display on the front panel indicates the operation status and any pending fault conditions when an over temperature or power supply fault has occurred. The unit can be returned to normal operation when the condition has been cleared; as with the other functions, this can be readily accomplished through a front panel switch. The unit also includes digital control for both local and remote control of the amplifier. The 8-bit RISC microprocessor controller board provides IEEE-488 (GPIB) and asynchronous full duplex RS-232 communication control of all amplifier functions.

 

Functions and Specifications of the Amplifier Research 75A250A Amplifier Include:

 

RATED POWER OUTPUT: 75 watts minimum

 

INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum

 

POWER OUTPUT @ 3dB COMPRESSION

Nominal: 100 watts

Minimum: 75 watts

 

POWER OUTPUT @ 1dB COMPRESSION

Nominal: 75 watts

Minimum: 50 watts

 

FLATNESS: ± 1.5 dB maximum

 

FREQUENCY RESPONSE: 10 kHz - 400 MHz instantaneously

 

GAIN (at maximum setting): 49 dB minimum

 

GAIN ADJUSTMENT (continuous range): 18 dB minimum

 

INPUT IMPEDANCE: 50 ohms, VSWR 1.5:1 maximum

 

OUTPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum

 

MISMATCH TOLERANCE: 100% of rated power without foldback. Will operate

without damage or oscillation with any magnitude and phase of source and load impedance.

 

MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse

modulation appearing on the input signal

 

NOISE FIGURE (above 1.0 MHz): 6 dB typical

 

HARMONIC DISTORTION: Minus 20 dBc maximum at 50 watts

 

THIRD ORDER INTERCEPT POINT: 57 dBm typical

 

PRIMARY POWER: .90-135/180-270 VAC 47 to 63 Hz, single phase 400

watts maximum