RENT Amplifier Research 500A250A Amplifier
The Amplifier Research 500A250A Amplifier is a self-contained, air-cooled, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull LDMOS circuitry is utilized in all high power stages in the interest of lowering distortion and improving stability.
The AR 500A250A Amplifier, when used with an RF sweep generator, will provide a minimum of 500 watts of swept power. The Amplifier Research 500A250A is equipped with a Digital Control Panel (DCP) which provides both local and remote control of the amplifier. The DCP uses a 3.75 inch diagonal graphic display, menu assigned softkeys, a single rotary knob, and four dedicated switches to offer extensive control and status reporting capability.
The display provides operational presentation of Forward Power and Reflected Power plus control status and reports of internal amplifier status. Special features include a gain control, forward RF sample port, and a reflective RF sample port for precise power measurements.
All amplifier control functions and status indications are available remotely in GPIB/IEEE-488, RS-232 and USB format. The buss interface connectors are located on the rear panel and positive control of local or remote operation is assured by a keylock on the front panel of the amplifier.
High efficiency universal input, power factor corrected switching power supplies provides DC to all internal subassemblies. The AR 500A250A provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, particle accelerators, plasma generation, communications and use as a driver for higher power amplifiers.
Specifications of the Amplifier Research 500A250A Amplifier include:
RATED OUTPUT POWER ............................................... 500 watts
INPUT FOR RATED OUTPUT .......................................... 1.0 milliwatt maximum
POWER OUTPUT @ 3 dB compression
Nominal ................................................................ 600 watts
Minimum ............................................................... 500 watts
POWER OUTPUT @ 1 dB compression
Nominal ................................................................ 500 watts
Minimum ............................................................... 350 watts
FLATNESS .....................................................................
± 2.0 dB maximum
FREQUENCY RESPONSE ............................................... 10 kHz–250 MHz instantaneously
GAIN (at maximum setting) ........................................... 57 dB minimum
GAIN ADJUSTMENT (continuous range) ......................... 10 dB minimum
INPUT IMPEDANCE ....................................................... 50 ohms, VSWR 1.5:1 maximum
OUTPUT IMPEDANCE ................................................... 50 ohms, nominal
MISMATCH TOLERANCE ............................................... 100% rated power without foldback up to 6.0:1 mismatch, above which may
limit to 250W reflected power. Will operate without damage or oscillation with
any magnitude and phase of source and load impedance.
MODULATION CAPABILITY ........................................... Will faithfully reproduce AM, FM, or pulse modulation appearing on the input
signal
HARMONIC DISTORTION ............................................. Minus 20 dBc maximum at 350 watts
THIRD ORDER INTERCEPT POINT .................................. 65 dBm typical
RF POWER DISPLAY ...................................................... 0–750 watts full scale
PRIMARY POWER .......................................................... 180 - 264 VAC
47–63 Hz, 2500 watts maximum @ 0.99 P.F. typical
CONNECTORS
RF input ................................................................. See Model Configuration
RF output ............................................................... See Model Configuration
Forward Sample ..................................................... BNC female on front panel (coupling factor 60 dB typical; data supplied)
Reverse Sample ...................................................... BNC female on front panel (coupling factor 60 dB typical; data supplied)
Safety Interlock ....................................................... 15 pin female Type D on rear panel
REMOTE CONTROL
IEEE-488 ............................................................ 24-pin female on rear panel
RS-232 .............................................................. 9 pin female Type D on rear panel
USB ................................................................... Type B female
Testimonials |
Thank you for your quick response to our need. -- Brenda S. Loveland, CO |